Ezgo RXV ELECTRIC Service & Repair Manual page 97

Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
Brake Pedal
GENERAL
For information on the Motor Brake see the Motor sec-
tion of this manual, Section G.
In the following text, there are references to removing and
installing bolts and other fasteners. Additional hardware (nuts,
washers, etc.) that are removed must always be installed in
their original positions unless otherwise specified. Non-speci-
fied torques are shown in the table in Section A.
To prevent possible injury or death from bat-
tery explosion, batteries should always be
removed before any servicing that could gen-
erate sparks or repairs that require welding or
cutting.
Accelerator Pedal
Pedal Cover
Fig. 1 Brake Pedal
Repair and Service Manual
The recommended method for
removing christmas tree rivets is
to slide a notched pry bar under
the head of the rivet and press
downward on the bar to pull the
rivet from the hole.
Fig. 2 Christmas Tree Rivet Removal
The brake pedal assembly is a modular unit that con-
tains the brake pedal, a rotary position sensor and a
brake switch. The only serviceable items in addition to
the entire brake pedal assembly are the pedal pad, the
rotary position sensor and the brake switch connector.
Brake Pedal Assembly
Tool List
Ratchet ........................................................................1
Torx Bit, T-20................................................................1
Hex Bit 6 mm ...............................................................1
Notched Pry Bar ..........................................................1
Insulated Wrench, 9/16"...............................................1
Flat Blade Screw Driver ...............................................1
Loctite® 242 ............................................................A/R
B
BRAKES
B
Christmas Tree
Fastener
Notched
Pry Bar
Qty.
Page J-1