Ezgo RXV ELECTRIC Service & Repair Manual page 54

ELECTRONIC SPEED CONTROL (AC MOTOR)
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
Accelerator Pedal Assembly
Tool List
Ratchet ........................................................................ 1
Torx Bit, T-20 ............................................................... 1
Torx Bit, T-30 ............................................................... 1
Torque Wrench, in. lbs................................................. 1
Notched Pry Bar .......................................................... 1
Insulated Wrench, 9/16" .............................................. 1
Loctite® 242 ............................................................ A/R
Using an insulated wrench, disconnect the bat-
tery cable at the negative (-), BL-, battery ter-
minal.
The accelerator pedal assembly is a modular unit, the
only serviceable items contained in the assembly are the
pedal pad, the rotary position sensor and the throttle
enable switch. The complete pedal assembly may be
replaced as a unit.
To access the pedal assembly, remove the upper rocker
panels, the lower rocker panels and the floormat (refer
to page C2 for removal of rocker panels and floormat).
1. Remove four christmas tree rivets securing pedal
cover to floorboard.
Page E-2
Fig. 3 Pedal Cover
2. Remove pedal cover.
Qty.
3. Remove three torx screws (2) securing accelerator
pedal assembly (1) to the floorboard. (Ref Fig. 4)
4. Disconnect the wires from the rotary position sensor
(5) and the throttle enable switch (12).
5. Remove the two Torx screws (4) from the rotary posi-
tion sensor (5) and remove sensor.
6. Remove the two Torx screws (8) from the throttle
enable switch (7) and remove the switch.
Installation
7. Align the slot in the rotary position sensor (5) to the
pivot shaft and rotate into position oriented as shown,
secure with two Torx screws (4). Use Loctite® 242;
according to product instructions; on the two Torx
screws.
8. Position the throttle enable switch (7) oriented as
shown, secure in place with two Torx screws (6). Use
Loctite 242; according to product instructions; on the
two Torx screws.
Repair and Service Manual
Pedal Cover
Christmas Tree Rivet