Accessory Wiring; Replacing The Accessory Wiring Harness - Ezgo RXV ELECTRIC Service & Repair Manual

ELECTRICAL COMPONENTS & WIRING
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
Headlight/Turnsignal
Front Splash Shield
ACCESSORY WIRING HARNESS
The Accessory Wiring Harness powers the headlights,
turn signals, brake lights, and the horn. The Accessory
Harness is routed under the floormat, recessed into the
floorboard. The section for the headlights and turn sig-
nals is routed through the cup holder and on top of the
front splash shield. The other end is routed under the
rear body then splits and runs over the rear splash
shields to the back of the vehicle for the rear lights. The
fuses for the harness are mounted on the front edge of
the Splash Shield covering the Controller.
Replacing the Accessory Wiring Har-
ness
Tool List
Notched Pry Bar .......................................................... 1
Torx Bit 27 IP ............................................................... 1
Ratchet ........................................................................ 1
Page K-10
Accessory
Harness
Horn
Horn Button
Fig. 21 Accessory Wiring Harness and Accessories
Repair and Service Manual
Relay
Fuse Holders
Rear Splash Shield
Torque Wrench, in. lbs. ................................................1
Insulated Wrench, 9/16"...............................................1
Using an insulated wrench, disconnect the bat-
tery cable at the negative (-) battery terminal.
To access the accessory wiring harness for replace-
ment, it is necessary to remove the upper and lower
rocker panels, the floormat, the front cowl, the top por-
tion of the cup holder and the seat bottom. See the Body
Section in this manual for instructions on removal and
replacement of these items.
1. Using an insulated wrench disconnect the accessory
harness from the battery pack.
2. Unplug the red and purple wires from the brake light
Qty.
relay to the main harness.
3. Unplug wires going to the headlights, turn signals,
headlight switch, turn signal switch, horn, fuel gage
(state of charge meter) and brake lights.
Brake Light/Turnsignal