Punch Home Position Adjustment; Flapper Solenoid Adjustment - Sharp MX-FNX9 Service Manual

Item Display Item
D STAPLE Staple binding
FRONT position
adjustment
(One position,
front)
E STAPLE Staple binding
BOTH position
adjustment (2
positions,
center)
F STAPLE Staple binding
PITCH position
adjustment (2
positions, pitch)
G PUNCH Punch center
CENTER adjustment
H PUNCH Punch hole
HOLE position
adjustment
[Screen]
SIMULATION NO.03-10
TEST
FINISHER ADJUSTMENT
A: 10 ; FRONT ADJUST
A: 10
B: 10 ; REAR ADJUST
C:100 ; STAPLE REAR
[ 2~ 18 ]
D:100 ; STAPLE FRONT
ADJ 3

Flapper solenoid adjustment

When the flapper solenoid is disassembled, an adjustment is
required when assembling. (Disassembly and assembly: Refer to
6-2.)
Variation Change direction
0.155mm Large value: The
distance between the
staple position and the
paper edge becomes
longer.
Small value: The
distance between the
staple position and the
paper edge becomes
shorter.
0.155mm Large value: The
staple position is
shifted to the bottom
from the center.
Small value: The
staple position is
shifted to the front
from the center.
0.155mm Large value: The pitch
of 2 positions
becomes greater.
Small value: The pitch
of 2 positions
becomes smaller.
0.1441mm Large value: The hole
position is shifted to
the bottom from the
center.
Small value: The hole
position is shifted to
the front from the
center.
0.2584mm Large value: The
distance between the
hole position and the
paper rear edge
becomes shorter.
Small value: The
distance between the
hole position and the
paper rear edge
becomes longer.
0
CLOSE
OK
MX-FNX9 ADJUSTMENTS 8 – 2
ADJ 4
Punch home position
adjustment
If the punch unit dose not function, turn the dial to make the punch
align to the home position. By making the punch align to the home
position, only the paper feed comes possible.
HOME