General; Outline Of The Transport Path - Sharp MX-FNX9 Service Manual

2. General

This chapter describes operations of the inner finisher. The major operation modes are as follows:
• Non-sort mode
• Offset mode
• Staple mode
• Non-sort mode + punch
• Offset mode + punch
• Staple mode + punch
In this chapter, the basic operations of the non-sort mode, the offset mode, and the staple mode are described.

3. Outline of the transport path

The outline of the path is shown below.
No.
1 Tray
2 Bundle exit roller
3 Paddle
4 Alignment plate
5 Paper exit roller
6 Take-up belt
7 Inlet port sensor (FED)
8 Inlet port roller
1 2 3
15
Name
MX-FNX9 OPERATIONAL DESCRIPTIONS 5 – 5
4 5 6 7 8
14 13 12
No.
9 Punch pin
10 Paper rear edge sensor (FPPEND)
11 Main unit paper exit roller
12 Stapler
13 Paper stopper
14 Empty sensor (FSTPD)
15 Paper holding lever
9 10
11
Name