Alignment Plate Position Sensor; Stapler Hp Sensor; Staple Shift Motor - Sharp MX-FNX9 Service Manual

(3) Alignment plate position sensor

1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Shift the staple unit to the front side.
3) Remove the bracket and remove the position sensor.

(4) Staple shift motor

1) Remove the inner finisher from the main unit. Refer to A-(1).
2) Remove the inner cover. Refer to A-(2).
3) Remove the rear cover. Refer to A-(3).
4) Remove the reverse guide unit. Refer to A-(5).
5) Remove the roller up/down motor. Refer to B-(6).
6) Remove the E-ring, the flange and the gear pulley, and remove
the gear.
7)

(5) Stapler HP sensor

1)
2)
3)
E. Paper exit tray section
(1) Paper surface sensors 1, 2
1)
2)
3)
4)
5)
MX-FNX9 DISASSEMBLY AND ASSEMBLY 6 – 8
Disconnect the connector from the PWB, and remove the sta-
ple shift motor.
Remove the inner finisher from the main unit. Refer to A-(1).
Remove the inner cover. Refer to A-(2).
Put the inner finisher upside down, and remove the stapler HP
sensor.
Remove the inner finisher from the main unit. Refer to A-(1).
Remove the inner cover. Refer to A-(2).
Remove the tray unit. Refer to B-(10).
Remove the load cover. Refer to C-(1).
Remove the parts, and remove the sensor lever.