Sony HDV HVR-1500 Service Manual page 192

3. Information to use the tracking alignment tape (XH2-1AST)
Check the following items before entering the tracking adjustment mode.
. How to enter the maintenance menu, refer to Section 4-2-2.
. How to exit the maintenance menu, refer to Section 4-2-3.
4. Connecting the tape path adjustment tool
To adjust the tape path, use the tape path adjustment board (DJ-461), tape path tool connection cable (DJ-
472), tape path tool power supply cable (DJ-500), and DC regulated power supply.
(1) Set the output of the DC regulated power supply to +12 Vdc/_12 Vdc.
(2) Insert the connector of the tape tape path tool connection cable (DJ-472) into the connector (CN4) of
the path adjustment board (DJ-461).
(3) Insert another connector of the tape path tool connection cable (DJ-472) into the connector (CN3) on
the RP-133 board.
(4) Insert the connector of the tape path tool connection cable (DJ-500) into the connector (CN2) of the
tape path adjustment board (DJ-461).
(5) Connect the tape path tool power supply cable (DJ-500) to the DC regulated power supply.
Tape path tool
connection cable
(DJ-472)
Not used.
7-2
Tape path adjustment board (DJ-461)
CN4
RP-133 board
CN3
DC regulated power supply
CN2
Red
Black Blue
Tape path tool power supply cable
(DJ-500)
HVR-1500