Sony HDV HVR-1500 Service Manual page 127

4. Reattaching the brake assembly
(1) Insert the harness of the brake assembly in a
square hole on the left side of the chassis to
bring it to the back side of the unit.
(2) Fit the slotted hole shown in the brake
assembly figure on the pin on the brake
release plate and further more fit the hole and
slotted hole in the brake base assembly on the
two reference pins of the MD chassis respec-
tively, and fix it with the three precision
screws.
Tightening Torque : 0.1 N.m {1 kgf.cm}
5. Reconnecting the connector
(1) Draw out the harness of the brake solenoid to
bring it to the back side of the unit with
tweezers.
(2) Reconnect the harness to the connector
(CN15) on the DR-428BG board.
6. Checking the performance
(1) Power on the unit and press the 7, [MENU]
keys simultaneously to activate the mainte-
nance menu.
(2) Following the pop-up menu in the mainte-
nance menu, enter SERVO CHECK,
PLUNGER CHECK, REEL BRAKE in order
and select REEL BRAKE.
(3) Check that the brake solenoid ON/OFF
switches smoothly by presing the 9, 0 keys.
HVR-1500
Precision screw
P1.4 x 3.5
Precision screw
P1.4 x 3.5
Harness
Slotted hole
Chassis
Hole
CN15
Pin of break release plate
Reference pins
Brake assembly
Precision screw
Slotted hole
P1.4 x 3.5
Brake base
assembly
Hole
6-11