Replacement
1. Disconnecting the connector
Disconnect the harness from the connector
(CN15) on the DR-428BG board located on the
back side of the MD chassis with tweezers.
n
Be careful not to suffer injury at hand by chassis
during the disconnection.
2. Removing the brake assembly
(1) Remove the three precision screws securing
the brake assembly.
(2) Pull out the harness of the solenoid from the
square hole in the left side of the chassis with
the brake assembly lifted up.
HVR-1500
Precision screw
P1.4 x 3.5
Precision screw
P1.4 x 3.5
Brake assembly
Harness
Chassis
Hole
Precision screw
P1.4 x 3.5
CN15
6-9