Sony HDV HVR-1500 Service Manual page 142

5. Reattaching the RMP (S1) retainer
assembly
(1) Fit the two positioning holes in the RMP (S1)
retainer assembly on the two positioning pins
on the MD chassis.
(2) Tighten the two precision screws to fix the
RMP (S1) retainer assembly while drawing
lightly the S tension regulator arm assembly
in the arrow direction.
6. Reconnecting the connector
Reconnect the flexible card wire to the connector
(CN14) on the DR-428BG board located on the
back side of the MD chassis.
m
. Be careful not to insert the flexible card wire
obliquely.
. Do insert the flexible card wire straight and
securely as far as it will go.
. Take care not to fold the flexible card wire.
This shortens the life of the flexible card wire.
7. Checking the performance
Check the S/T reel tables move smoothly by
turning the reel shift motor gear by a skewer.
Adjustment after Replacement
8. S-REEL ONLY alignment
(Refer to Section 4-3-4.)
9. TENSION alignment
(Refer to Section 4-3-4.)
10. Tape path adjustment
(Refer to Section 7-2.)
6-26
Precision screw
(a) P1.4 x 3.5
Positioning holes
Precision screw
(b) P1.4 x 3.5
RMP retainer
(S1) assembly
Positioning pins
S tension regulator arm
assembly
Screw (a)
HVR-1500