Sony HDV HVR-1500 Service Manual page 168

Replacement
1. Disconnecting the flexible card wire
Disconnect the flexible card wire from the
connector (CN16) on the DR-428BG board
located on the back side of the MD chassis.
2. Moving the S/T reel tables
Turn the reel shift motor gear in the arrow
direction by a skewer and bring the S/T reel
tables to the standard cassette position (the most
front side).
3. Removing the L push plate
Remove the L push plate. (Refer to Section 6-7.)
4. Removing the MIC spring
Unhook the hooks on the both ends of the MIC
spring which hold the MIC arm and the RLR
assemblies.
6-52
MIC assembly
flexible card wire
DR-428BG board
S reel table
RLR assembly
MIC spring
MIC assembly
CN16
Reel shift
motor gear
T reel table
HVR-1500