Drill A Hole In The Wall - LG AMNH096BTG0 Manuals

• Secure the Installation plates onto the Suspension
bolts (adjust level roughly.) using nuts, washers and
spring washers.
• Engage 2 hooks on the both left and right side of the
unit to the lower slot of Installation Plates.
• Adjust a level with a level gauge on the direction of
left-right, back-forth by adjusting suspension bolts.
• Move the hooks on the unit to the upper slot of
Installation Plates. Then the unit will be declined to
the bottomside so as to drain well.

Drill a Hole in the Wall

• Drill the piping hole with a ø70mm hole core drill.
Drill the piping hole at either the right or the left with
the hole slightly slanted to the outdoor side.
Copyright ©2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Anchor nut
Ceiling
Nut
Suspension
bolts
Center-line for the
piping hole
Indoor
- 59 -
Installation
235
Washer
820
Suspension bolt
Suspension
bolts
Spring
washer
Nut
Hangen
Max.
12mm Washer
WALL
Outdoor
LGE Internal Use Only