LG AMNH096BTG0 Manuals page 56

Installation
5. CVT Type Indoor Unit
- VB chassis
I Before Installing, prepare Installation Plates
• 'Installation Plates' are attached at the bottom of
indoor unit.
Detach them by removing each 3 screws at both
sides.
• Detach 'Side Plate (R,L)' by removing each 2 screws
on both sides.
• Pull the upper right and left side of 'Inlet Grille' to the
front, and it will stop at slightly tilted position.
• Unhook the 'Inlet hanger' from the 'Hanger screw' on
the both left and right side.
• Detach the 'Inlet Grille' from the Indoor Unit.
1) Installation on the ceiling
• Measure and mark the position for the
Suspension bolts and the piping hole.
• Drill the hole for anchor nut on the ceiling.
Before secure the Installation Plates, select the bent
direction of the Installion Plate to the inside or the
outside according to the installation circumstances.
• Drill the piping hole on the wall slightly tilted to the
outdoor side using a ø70 hole-core drill.
Copyright ©2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Install Plate
Inlet Grille
1076
1)
1236
2)
Indoor
- 56 -
Side Plate
Inlet hanger
Hanger
screw
265
Suspension
bolt
Center-line for the
piping hole
265
WALL
Outdoor
5~7mm
LGE Internal Use Only