Panasonic KX-NCP500 Getting Started page 43

Note
To confirm the connection to the secondary PBX after programming, (1) turn the IP-PT's power off,
and (2) hold the STORE button and 2 key while turning the power on.
KX-NT265 (Software version 2.00 or later only)
To start programming
Supply power to the IP-PT.
To set the IP address of the IP-PT
VOL
Press VOLUME to
select "Network".
IP Address*
To set the subnet mask address
VOL
Press VOLUME to
select "Subnet Mask".
To set the default gateway address (if required)
VOL
Press VOLUME to
select "Default GW".
To end programming
HOLD
Press HOLD to return
to the Menu screen.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
PROG.
Press PROGRAM
while "Searching" is displayed.
Press SP-PHONE. Press VOLUME to
select "DHCP (Disable)".
1
Press SP-PHONE.
Subnet Mask Address*
Press SP-PHONE.
Default Gateway Address*
Press SP-PHONE.
Press STORE.
4.3.1 Assigning the IP Addressing Information
VOL
Press SP-PHONE
twice.
2
3
The IP-PT will reboot
and can then be
registered to the PBX.
Press SP-PHONE.
Press SP-PHONE.
Getting Started 43