Connecting To The Lan; Connecting The Ipcmpr Card To The Lan - Panasonic KX-NCP500 Getting Started

2.4.1 Connecting the IPCMPR Card to the LAN

CAUTION
For earthing wire, green-and-yellow insulation is required, and the cross-sectional area of the conductor
must be more than 0.75 mm

2.4 Connecting to the LAN

2.4.1 Connecting the IPCMPR Card to the LAN
Refer to the following procedure to connect the IPCMPR card to the LAN.
When the IPCMPR card is connected to the LAN for the first time, you must assign IP addressing information
to the card. Refer to "4.1 Programming the PBX" for instructions.
Note
Make sure to set the port of the switching hub that connects to the IPCMPR card to operate under "Auto
Negotiation" mode.
Attaching a ferrite core to the cable
1.
Wrap the cable once around the ferrite core, leaving 3 cm between the ferrite core and the connector.
2.
Close the case of the ferrite core.
Note
If you need to open the ferrite core, use a flathead screwdriver to unlatch the case.
10 Getting Started
or 18 AWG.
2
3 cm