Panasonic KX-NCP500 Getting Started page 17

2.
Plug the AC power cord into the PBX and pass the cord through the hook clip as indicated. Push the hook
clip in the direction of the arrow until it clicks.
Note
For safety reasons, do not stretch or pinch the AC power cord.
3.
Plug the other end of the cord into an AC outlet and turn on the PBX. The RUN indicator will flash.
4.
While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared and the PBX will be initialised to the default values.
To earthed AC Outlet
3.1 Starting the PBX
Getting Started 17