Bellfires BCC-28 Tall Installation Manual page 18

Bellfires® BCC
18-1
18-2
18-3
18-4
Lay 1" (25mm) precut Hollow Wool Insulation Blanket (Part # 6) on 22ga. 304-L SS floor pan of shell. (Part # 4) Be sure
that supplied insulating blanket fits tight against floor of enclosure. (18-1) Position supplied precut 3" thick Hollow Wool
Thermal Insulating Blanket (Part #7) around rear of shell. (18-2) Using provided spray glue ( Part #8) spray front of pre-
cut Hollow Blanket (Part # 7). Center Bellfires® refractory firebox (Part # 8) into shell enclosure. (18-3) Place side flare
panels ( Parts 9a & 9b) in place on either side of firebox, striving for a tight flare joint. Snug up Hollow Wool tightly
against rear of refractory firebox and flares. Insulating blankets must fit snugly against fireback to allow for perlite insulat-
ing fill.
Place hearth components ( Parts #11a & 11b) into enclosure. Keep front edge of hearth stretcher flush with front edge of
fireplace base. This will set correct firebox position. (18-4)
18