JVC UX-G6 Service Manual page 7

Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:
1 Front: No obstructions and open spacing.
2 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
3 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand
with a height of 10 cm or more.
Precaución: el aparato debe estar bien ventilado
Para evitar posibles riesgos de descargas eléctricas e incendios y prevenir cualquier posible daño, coloque el
aparato del modo siguiente:
1 Parte delantera: No ponga nada delante, deje el espacio libre.
2 Laterales/ parte superior/ parte trasera: No se debería colocar nada en las áreas y las distancias que se
detallan a continuación.
3 Parte inferior: Coloque el aparato sobre una superficie recta. Debe haber buena circulación de aire; para
ello, coloque el aparato sobre una base a una altura mínima de 10 cm.
Front view
Vista frontal
15 cm
1 cm 1 cm
15 cm
AX-UXG6
XT-UXG6
TD-UXG6
XM-G6
– G-3 –
Introduction
We would like to thank you for purchasing one of our JVC products.
Before operating this micro component system, read this manual carefully
and thoroughly to obtain the best possible performance from your system,
and retain this manual for future reference.
About This Manual Power sources
• When unplugging from the wall outlet, always pull the
This manual is organized as follows:
• The manual mainly explains operations using the buttons
and controls on the units. You can also use the buttons
on the remote control if they have the same or similar
Moisture condensation
names (or marks) as those on the units.
If operation using the remote control is different from Moisture may condense on the lens inside the units in the
that using each unit, it is then explained.
following cases:
• Basic and common information that is the same for many • After starting heating in the room
functions is grouped in one place, and is not repeated in • In a damp room
each procedure. For instance, we do not repeat the
• If the units are brought directly from a cold to a warm
information about turning on/off the system, setting the
volume, changing the sound effects, and others, which
Should this occur, the system may malfunction. In this case,
are explained in the section "Basic Settings" and leave the units turned on for a few hours until the moisture
"Common Operations" on pages 10 to 13. evaporates, unplug the AC power cord, and then plug it in
• The following marks are used in this manual:
again.
Gives you warnings and cautions to Others
prevent from a damage or risk of fire/
• Should any metallic object or liquid fall into a unit, unplug
electric shock.
Also gives you information which is not
good for obtaining the best possible
• If you are not going to operate the units for an extended
performance from the units.
Gives you information and hints you had
better know.
Precautions
If anything goes wrong, unplug the AC power cord and
consult your dealer.
Installation
• Install in a place which is level, dry and neither too hot
nor too cold — between 5˚C and 35˚C.
• Install the units in a location with adequate ventilation to
prevent internal heat buildup in the units.
• Leave sufficient distance between the units and the TV.
• Keep the speakers away from the TV to avoid interference
with TV.
DO NOT install the units in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust or vibration.
1
Side view
Vista lateral
15 cm
15 cm 15 cm
AX-UXG6
XT-UXG6
TD-UXG6
XM-G6
10 cm
plug, not the AC power cord.
DO NOT handle the AC power cord with wet
hands.
place
the units and consult your dealer before operating any
further.
period of time, unplug the AC power cord from the wall
outlet.
DO NOT disassemble the units since there are
no user serviceable parts inside.
IMPORTANT FOR LASER PRODUCTS
IMPORTANTE PARA PRODUCTOS LÁSER
REPRODUCTION OF LABELS / REPRODUCCIÓN DE ETIQUETAS /
2 WARNING LABEL, PLACED INSIDE THE UNIT
1 CLASSIFICATION LABEL, PLACED ON EXTERIOR
SURFACE 1
2 ETIQUETA DE ADVERTENCIA, PEGADA EN EL
1 ETIQUETA DE CLASIFICACION, PROVISTA SOBRE LA
SUPERFICIE EXTERIOR
CLASS 1
LASER PRODUCT
1. CLASS 1 LASER PRODUCT
2. DANGER: Invisible laser radiation when open and interlock failed
or defeated. Avoid direct exposure to beam.
3. CAUTION: Do not open the top cover. There are no user
serviceable parts inside the Unit; leave all servicing to qualified
service personnel.
1. PRODUCTO LÁSER CLASE 1
2. PELIGRO: En el interior hay radiación láser invisible. Evite el
contacto directo con el haz.
3. PRECAUCIÓN: No abra la tapa superior. En el interior de la
unidad no existen piezas reparables por el usuario; deje todo
servicio técnico en manos de personal calificado.
– G-4 –
Contents
Introduction .......................................................... 1 Playing Back a Tape ........................................... 20
About This Manual ............................................................... 1
Precautions ........................................................................... 1
Contents ................................................................. 2
Location of the Buttons and Controls ................. 3
Recording onto a Tape ........................................ 22
Front Panels .......................................................................... 4
Remote Control .................................................................... 5
Getting Started ...................................................... 6
Unpacking ............................................................................ 6
Putting the Batteries into the Remote Control ..................... 6
Using the Timers ................................................. 25
Connecting the System Control Cables and the External
Wire .................................................................................. 6
Connecting MD Recorder XM-G6 ....................................... 7
Connecting Sub Woofer System ........................................... 7
Connecting Antennas ............................................................ 7
Connecting Speakers ............................................................ 8
Maintenance and Additional Information ........ 29
Connecting Other Equipments ............................................. 9
Basic Settings ...................................................... 10
Setting the Clock ................................................................ 10
Setting the Display Illumination (Dimmer) ....................... 10
Troubleshooting .................................................. 31
Common Operations .......................................... 11
Specifications ....................................................... 32
Adjusting the Voltage Selector ........................................... 11
Turning On the Power and Selecting the Sources .............. 11
Adjusting the Volume ......................................................... 12
Reinforcing the Bass Sound ............................................... 12
Adjusting Bass and Treble Sounds ..................................... 12
Operating the Sliding Panel ................................................ 13
Listening to the External Equipment .................................. 13
Listening to FM and AM Broadcasts ................ 14
Setting the AM Tuner Interval Spacing .............................. 14
Tuning in a Station ............................................................. 14
Presetting Stations .............................................................. 15
Playing Back a CD .............................................. 16
Playing Back the Entire Disc — Normal Play ................... 16
Searching and Skipping Tracks .......................................... 17
Programing the Playing Order of the Tracks
— Program Play ............................................................. 17
Playing at Random — Random Play .................................. 19
Repeating Tracks — Repeat Play ....................................... 19
UX-G6/FS-G6
INTERIOR DE LA UNIDAD
DANGER: Invisible laser VARNING: Osynlig laser-
radiation when open and strålning när denna del är
interlock failed or defeated. öppnad och spärren är
AVOID DIRECT EXPOSURE urkopplad. Betrakta ej
TO BEAM. (e) strålen. (s)
ADVARSEL: Usynlig laser- VARO: Avattaessa ja suo-
stråling ved åbning, når jalukitus ohitettaessa olet
sikkerhedsafbrydere er ude alttiina näkymättömälle
af funktion. Undgå udsæt- lasersäteilylle. Älä katso
telse for stråling (d) säteeseen. (f)
Playing Back a Tape — Basic Operation ........................... 20
Fast-Winding a Tape ........................................................... 21
Searching and Skipping to Each Program
— Music Scan ................................................................ 21
Playing Back Dolby-Recorded Tape .................................. 21
Manual Recording onto a Tape ........................................... 22
Recording in Auto Reverse ................................................ 23
Synchronized Recording from a CD .................................. 24
Recording from the External Equipment ........................... 24
Using Recording Timer ...................................................... 25
Using Daily Timer .............................................................. 26
Using Sleep Timer .............................................................. 28
Timer Priority ..................................................................... 28
Handling CDs ..................................................................... 29
Handling Cassette Tapes .................................................... 30
Types of Cassette Tapes ...................................................... 30
2
1-7