JVC UX-G6 Service Manual page 20

UX-G6/FS-G6
Removing the regulator board
• Prior to performing the following procedure,
remove the top cover.
1. Disconnect the card wire from connector CN908
on the main board.
2. Disconnect the harness from connector CN906
on the main board.
3. Remove the two screws G attaching the regula-
tor board.
Removing the transformer assembly
• Prior to performing the following procedure,
remove the top cover.
1. Disconnect the harness from connector CN904,
CN905 and CN903 on the main board.
2. Remove the four screws H attaching the trans-
former assembly.
3. Remove the cord stopper and the voltage selec-
tor as shown in Fig.9.
(If necessary, unsolder the soldered point and cut
off the belt fixing the harness.)
2-4
(See Fig.10)
CN906
Main board
CN908
(See Fig.11)
Regulator board
G
G
Fig. 10
Power transformer
H
Voltage selector
Fig. 11
H
CN905
CN903
CN904
Cord stopper