Troubleshooting
If you are having a problem with your system, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the units has been physically damaged, call a qualified
person, such as your dealer, for service.
Symptom
Possible Cause
No sound is heard.
•
Connections are incorrect, or
loose.
•
Headphones are connected.
•
Volume level is set to "– –".
Poor radio reception.
•
The antenna is not connected
correctly.
•
The AM loop antenna is too close
to the units.
•
The FM antenna is not properly
extended and positioned.
Unable to record onto a tape.
•
You are using a tape without a
protect tab.
•
Tape-type detection slots are
covered by foreign matters.
The CD skips.
•
The CD is dirty or scratched.
Unable to operate using the remote
•
The path between the remote
control.
control and the remote sensor on
the front panel is blocked.
•
The batteries have lost their
charge.
Loaded CD and tape cannot be
•
The main AC power cord is not
ejected.
plugged in.
•
The system is under the recording
operations.
The CD does not play.
•
The CD is upside down.
Operations are disabled.
•
The built-in microprocessor has
malfunctioned due to external
electrical interference.
31
Action
•
Check all connections and make
corrections (see pages 6 – 9).
•
Disconnect the headphones (see
page 12).
•
Adjust the volume again (see
page 12).
•
Reconnect the antenna securely.
•
Change the position and direction
of the AM loop antenna.
•
Extend FM antenna to the best
reception position (see page 7).
•
Cover the hole with adhesive tape
(see page 30).
•
Remove the foreign matters.
•
Clean or replace the CD (see page
29).
•
Remove the obstruction.
•
Replace the batteries (see page 6).
•
Plug in the AC power plug.
•
Stop the recording if required (see
pages 23).
•
Put in the CD with the label side
up.
•
Unplug the system then plug it
back in.
Specifications
Stereo Amplifier
AX-UXG6
Speaker System
Output power
Type:
48 W (24 W + 24 W) at 6 Ω (Max.)
Speaker unit:
6 Ω (6 Ω to 16 Ω allowance)
Load impedance:
Audio output level/Impedance (at 1 kHz):
Sub Woofer 800 mV/440 Ω
Impedance:
Frequency range:
Power requirement:
[A] AC 110 V – 120 V/220 V
Sound Pressure Level:
– 240 V
,
Dimensions (approx.):
[B] AC 115 V/230 V
(adjustable with the voltage
Mass (approx.):
selector), 50 Hz/60 Hz
Power consumption:
[A] 59 W (at operation)
Supplied Accessories
[B] 54 W (at operation)
See page 6.
2.0 W (on standby: with
Dimmer)
Design and specifications are subject to change
Dimensions (approx.):
182 mm x 81 mm x 313 mm
without notice.
(W/H/D)
Mass (approx.):
3.8 kg
US and foreign patents licensed from Dolby
Laboratories Licensing Corporation.
Compact Disc/Tuner
XT-UXG6
Audio input sensitivity/Impedance (at 1 kHz):
AUX: 400 mV/47 kΩ
[CD section]
Digital output:
OPTICAL DIGITAL OUT
Wow and flutter:
Immeasurable
[Tuner section]
FM tuning range:
87.50 MHz – 108.00 MHz
AM tuning range:
531 kHz – 1,710 kHz (at 9 kHz
channel spacing)
530 kHz – 1,710 kHz (at 10 kHz
channel spacing)
181 mm x 81 mm x 313 mm
Dimensions (approx.):
(W/H/D)
Mass (approx.):
1.9 kg
Cassette Deck
TD-UXG6
Frequency response :
Normal
30 Hz – 15,000 Hz
High position
30 Hz – 16,000 Hz
Wow and flutter:
0.1 % WRMS
Dimensions (approx.):
181 mm x 81 mm x 304 mm
(W/H/D)
Mass (approx.):
1.9 kg
UX-G6/FS-G6
SP-UXG6
2-way Bass-Reflex Type
Woofer
11.5 cm Cone x 1
Tweeter
3.0 cm Balanced
Dome x 1
6 Ω
40 Hz – 20,000 Hz
85.5 dB/W•m
157 mm x 295 mm x 232 mm
(W/H/D)
3.3 kg each
32
1-15