JVC UX-G6 Service Manual page 53

4. Leaf switch replacement
Remove the two screws H securing the leaf switch
board.
5. Mechanism base
(1) Pull out the reel disk.
(2) Detach the brake arm.
Pull up the brake arm by releasing the stopper
on the brake arm shaft.
(3) Remove the four switches I securing the
mechanism base unit.
(4) Pull out the reel idle gear.
(5) Turn the unit over and remove the screw J.
Detaching the flywheel
1. Remove the C washers and washers from the
capstan.
2. Pull out the flywheel.
Note: When assembling, be sure to replace the C
washers and washers on the same sides they
came from.
H
Unsolder
Fig. 8
Guide
Reel idle gear
I I
I
Fig. 9
C washers
washers
Fig. 10
UX-G6/FS-G6
H
J
I
2-37