JVC UX-G6 Service Manual page 22

UX-G6/FS-G6
Removing the slide gear motor assembly
• Prior to performing the following procedure,
remove the top cover and the regulator board .
1. Disconnect the harness from connector CN907
on the main board.
2. Remove the two screws O attaching the slide
gear motor assembly.
3. Remove the belt from the motor pulley.
4. Remove the two screws P and the screw Q
attaching the motor assembly.
2-6
(See Fig.19 to 21)
Slide gear motor
assembly
O
O
Main board
CN907
Fig. 19
Belt
P
Fig. 20
Fig. 21
Motor pulley
Q