JVC UX-G6 Service Manual page 49

Micro component system
Hide thumbs Also See for UX-G6:
Table of Contents

Advertisement

Removing the rear panel
(See Fig.6 and 7)
Prior to performing the following procedure,
remove the top cover.
1. Remove the three screws E attaching the rear
panel on the back of the body and release the
two joints "c" on both sides while moving the rear
panel upward
2. Disconnect the harness from connector CN633
on the main board.
(When disconnecting the harness from the rear
panel, unhook the upper and lower four hooks of
the wire stopper on the back of the rear panel
and pull out the harness outward.)
Removing the cassette mechanism
assembly (See Fig.8)
Prior to performing the following procedure,
remove the top cover and the front assembly.
1. Disconnect the card wire from connector CN647
and the harness from CN635 on the main board
respectively.
2. Disconnect the harness from the connector on
the motor board in the cassette mechanism
assembly.
3. Remove the four screws F and detach the
cassette mechanism assembly upward.
UX-G6/FS-G6
E
Rear panel
Joint c
Joint c
E
Fig. 6
Rear panel
Wire stopper
CN633
Main board
Fig. 7
Fig. 7
Fig. 7
CAUTION: Lift the lock and
pull out the wire.
CN633
Fig.7-1
Cassette mechanism assembly
F
F
Connector on the
motor board
F
CN635
CN647
Main board
Fig. 8
2-33

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs-g6Ax-uxg6Xt-uxg6Td-uxg6Sp-uxg6

Table of Contents