Removing the CD mechanism assembly
main & CD servo board (See Fig.12 to 14)
•
Prior to performing the following procedure,
remove the top cover, the front panel assembly,
the rear panel, the system control board and the
analog in/digital out board.
1. Remove the three screws I attaching the CD
mechanism assembly and the screw J attaching
the main & CD servo board.(The CD mechanism
assembly will be detached together with the main
& CD servo board.)
2. Remove the three screws K attaching the main &
CD servo board.
3. Disconnect the harness from connector CN440
and CN438 on the main & CD servo board on the
back of the CD mechanism assembly.
4. Remove the card wire from connector CN439 on
the main & CD servo board.
Main & CD servo board
J
CD mechanism assembly
I
I
Fig. 13
Removing the front board (See Fig.15)
•
Prior to performing the following procedure,
remove the top cover and the front panel assem-
bly.
1. Remove the seven screws L attaching the front
board in the front panel assembly.