Location And Function Of Parts And Operation; Front/Top/Bottom; Rear - Sony XCG-V60E Technical Manual

Location and Function of Parts and Operation

Front/Top/Bottom

a Lens mount (C-mount)
Note
The lens must not project more than 10 mm (13/32 inch)
from the lens mount.
1 Lens mount face 2 10 mm (13/32 inch) or less
b Guide screw holes (Top)
c Guide screw holes/Tripod screw holes (bottom)
When using a tripod, use these four screw holes to attach
a VCT-ST70I tripod adaptor.
Note
Use the screws (M2 × 6 (2); M3 × 8 (2)) supplied with
the tripod adaptor when installing it on the camera
module.
d Reference screw holes (bottom)
These precision screw holes are for locking the camera
module. Locking the camera module into these holes
secures the optical axis alignment.
Note
Refer to XCG-V60E/XCG-SX97E/XCG-SX99E/
XCG-U100E/XCG-5005E Demensions in page 35 for
about the position/size of the Guide hole and the
Reference hole.

Rear

e DC IN (DC power input) connector (12-pin)
You can connect a camera cable CCXC-12P05N etc. to
input the +12 V DC power supply. The pin configuration
of this connector is as follows. For details on the pin
arrangement, see the following table.
Pin No. Signal
1 Ground
2 +12 V DC
3 Ground
4 Multi-function
*
output (TTL)
5 Multi-function
*
output (ISO –)
6 Multi-function
*
output (ISO +)
* About multi-function output
You can select from the following signals based on
settings.
Exposure output/strobe control outputs/GPO (fixed
value Hi or Low)
See page 8 for pin 4 TTL output level and pin 11
trigger input level specifications.
f RJ45 connector
You can connect a LAN cable to this connector to
control the camera module from a host device to output
image to a host device.
Pin No. Signal
1 TP1 +
2 TP1 –
3 TP2 +
4 TP3 +
Pin No. Signal
7 GPI input (ISO +)
8 Ground
9 NC
10 NC
11 Triger input
12 GPI input (ISO –)
Pin No. Signal
5 TP3 –
6 TP2 –
7 TP4 +
8 TP4 –
7