Specifications - Jh 20T17 Mmd-Xxx-Axxx (Ccfl Version) - Hatteland JH 15T17 MMD series User Manual

Specifications - JH 20T17 MMD-xxx-Axxx (CCFL version)

SPECIFICATIONS
TFT Technology:
• High Quality SHARP TFT
• 20.1 inch viewable image size
• a-Si TFT (Thin Film Transistor) Active Matrix
TFT Characteristics:
• Pixel Number : 1600 x 1200
• Pixel Pitch (RGB) : 0.255 (H) x 0.255 (V) mm
• Response Time : 20 ms (typical), rise + fall
• Contrast Ratio : 500:1 (typical)
• Light Intensity : 250 cd/m2 (typical)
• Viewable Angle : +/- 88 deg. (typical) (Up/Down/Left/Right)
• Active Display Area : 408.0 (H) x 306.0 (V) mm
• Max Colors : 16.7 millions
Synchronisation:
Sync Signal:
• Digital separate synchronisation
• Composite synchronisation
• Synchronisation on green.
• Auto detects VGA -> WUXGA, interlaced and non interlaced
• Video Signal : Analog RGB 0,7Vp-p
: Input Impedance 75 Ohm
Synchronisation Range:
• Horizontal : 15,0 kHz to 91,1 kHz
• Vertical : 60 Hz* to 85 Hz
* Recommended for optimal picture quality
Supported Signals:
Resolutions:
• VGA : 640 x 480 (including 640 x 350)
• SVGA : 800 x 600 (including 720 x 400)
• XGA : 1024 x 768
• SXGA : 1280 x 1024
• UXGA : 1600 x 1200*
• WUXGA : 1920 x 1200
* Recommended for optimum picture quality. (60 Hz only)
Video Signals (with Multifunction Cable):
• Interlaced NTSC and PAL/SECAM video
• Composite video
Power Specifications:
Power Supply Options:
• 115&230VAC - 50/60Hz - JH 20T17 MMD-Axx-xxxx
• 24 VDC - JH 20T17 MMD-Dxx-xxxx
Power Consumption:
Operating : 100 W (max)
Typical Type Numbers:
• JH 20T17 MMD-AA1-AAAA = Standard AC, Keypad controls only
• JH 20T17 MMD-DA1-AAAC = Standard DC & Capacitive Touch Screen
• JH 20T17 MMD-AA1-AOBA = Standard AC, Bonded, Potmeter Controls, Buzzer
Buzzer-Potmeter-Keypad
MMD-xxx-xxBx
For a full overview, please review our typenumber sheet found on our website:
http://www.hatteland-display.com/pdflink/ind100780-1.php
T E S T I N G / A P P R O V A L S
IEC 60945 4th (EN 60945:2002)
ABS - American Bureau of Shipping
EU RO MR - Mutual Recognition
IND100129-102
Please visit www.hatteland-display.com for the latest electronic version.
Keypad
MMD-xxx-xxAx
This product have been tested / type approved by the following classification societies:
ClassNK - Nippon Kaiji Kyokai
BV - Bureau Veritas
Note: All specifi cations are subject to change without prior notice!
All specifications are subject to change without prior notice!
Physical Considerations:
• 534 (W) x 481 (H) x 87 (D) mm - 21.02" (W) x 18.93" (H) x 3.42" (D)
• Weight: 13.50 kg (approx)
Signal Terminals:
• DVI-I Signal IN
• RGB Signal IN
• RGB Signal OUT
• Multifunction
• USB I/O
• AC Power IN
• AC Power OUT
• DC Power IN
**Tested at recommended resolutions. The RGB output signal is at same resolution and sync as the
RGB input. The output is working even if the display unit is turned off, but power cable/supply must
be connected/provided.
Multifunction Cable:
Available factory standard cables, 30cm [11.81"] in length.
• VSD100692-1
• VSD100692-3
• VSD100692-4
Customized cables are possible to support more built-in signals, like: RS-485, RS-422/
RS-485, Buzzer, ON/OFF, Touch (PS/2), 1 x S-Video IN, Remote External User Controls,
Alternative Keypad interface (i2c) and reserved for other signals. Custom cable lengths
can be manufactured.
User Controls:
On front bezel - Keypad control (IP66) xxx-xxAx models:
• Power On/Off and On Screen Display Menu (push button)
• Brightness Control (up/down - push buttons)
• Hotkeys (left/right - push buttons)
• Mode Status Red/Green/Orange Illuminated LED-Ring Indicator
On front bezel - Potmeter control (IP66) xxx-xxBx models:
• Power On/Off and On Screen Display Menu (push button)
• Brightness Control (rotary control)
• Hotkeys (left/right - push buttons)
• Mode Status Red/Green/Orange Illuminated LED-Ring Indicator
• Speaker / Buzzer
Environmental Considerations:
• Operating
• Storage
• IP Rating
• Compass Safe Dist. : JH20T17MMD-xxx-xxxx - Std: 75cm Steering: 35cm
Safety Considerations:
Even although the test conditions for bridge units provide for a maximum
operating temperature of 55°C, continuous operation of all electronic
components should, if possible, take place at ambient temperatures of only
25°C. This is a necessary prerequisite for long life and low service costs.
Available Accessories:
• Cables
• JH MMDBR STD-A1 = Bracket (See user manual)
• JH MMDRO STD-A1 = Rotary Bracket (See user manual)
• JH 20TSV STD-B1 = Sun Visor (See user manual)
• JH 20VED STD-A1 = Vesa Bracket (See user manual)
• JH 20TWC STD-B1 = Water Cover (See user manual)
Factory Options:
• Capacitive Touch Screen / Optical Bonding Technology
• Color Calibrated models (ECDIS)
& C E R T I F I C A T E S
GL - Germanischer Lloyd
CCS - China Classification Society
60
: 1 x 29p DVI Female (or as RGB IN with adapter)
: 1 x 15p HD D-SUB (female)
: 1 x 15p HD D-SUB (female) - Clone of RGB IN**
: 1 x 160p D-SUB (female) - Also see table below
: 1 x TYPE B Conn. (female) Reserved for future use
: 1 x Std IEC Inlet
: 1 x Std IEC Outlet (5A max)
: 1 x 2p D-SUB Connector (male) - Amphenol FCC17
: 1 x 9P D-SUB (female) - RS-232 (COM1)
: 1 x 9P D-SUB (female) - RS-232 (COM1)
: 1 x 9P D-SUB (female) - RS-232 (COM Touch Screen)
: 3 x BNC (female) (Composite Video in)
: 1 x 9P D-SUB (female) - RS-232 (COM1)
: 3 x BNC (female) (Composite Video in)
: Temperature -15 deg. C to +55 deg. C
- Humidity up to 95%
: Temperature -20 deg. C to +60 deg. C
- Humidity up to 95%
: Protection (EN60529): IP66 front - IP20 rear
= Custom Multifunction Cable to support more signals
DNV - Det Norske Veritas
LRS - Lloyd's Register of Shipping
2/2