Table of Contents
Advertisement
General Questions
1) What processor does the Intel
The Intel S845WD1-E server board supports a single Pentium 4 or Celeron processor (in a
µPGA478 socket) with a system bus of 400 /533 MHz. At the time of launch, the Server
Board S845WD1-E will support 1.8 GHz to 2.53 GHz. For the latest supported speeds,
please refer to the Intel support website at
http://support.intel.com/support/motherboards/server/s845wd1-e
available at S845WD1-E launch).
2) How do I install and secure a processor on the S845WD1-E server board?
The processor connects to the server board S845WD1-E through the µPGA478 pin socket
connector. Make sure you use an adequate heat sink solution such as that provided with
the Branded Intel
board into a 1U chassis, you will need to use the 1U active heatsink that is provided in the
S845WD11U boxed board.
3) How many expansion slots does the Server Board S845WD1-E contain?
The Server Board S845WD1-E has three dedicated PCI connectors and one 1.5V only
AGP 4x port connector. All PCI slots support bus-mastering devices.
4) Does the Server Board S845WD1-E support STR (Suspend-to-RAM)?
The Server Board S845WD1-E supports STR when used with STR capable: Operating
system, add-in card(s), driver(s), and application(s). Operating systems, add-in cards,
drivers, and applications that do not support STR can cause problems when coming out of
different sleep states.
Memory Questions
1) What memory configurations are supported on the Server Board S845WD1-E?
The Server Board S845WD1-E supports DDR 200 and DDR 266 SDRAM Memory. There are
two DIMM sockets supporting up to two 184-pin DDR SDRAM Dual Inline Memory Modules
(DIMMs) with gold-plated contacts. The Server Board S845WD1-E is designed to support a
memory range of 64 MB minimum (using 64 Mbit technology) up to 2.0 GB maximum** [See note
below] (using 512 Mbit technology) that conforms to the latest Intel JEDEC specification
Addendums. The Server Board S845WD1-E can support ECC and non-ECC DIMMs.
NOTE:The Server Board S845WD1-E has been designed to support DIMMs based on 512 Mbit
technology for a maximum onboard capacity of up to 2.0 GB, but this technology has not been
validated (currently validated up to 1.0 GB using 256 Mbit technology) on this board. Please refer
to the Intel support website at
for additional information (site available at S845WD1-E launch).
2) What kind of problems might occur in a DDR SDRAM-based system that uses non-compliant
DIMMs?
SPD Troubleshooting Guide
Other Questions
®
Server Board S845WD1-E support?
®
®
Pentium
4 Processor. If you are integrating the S845WD1-E server
http://support.intel.com/support/motherboards/server/s845wd1-e
-9-
for more information (site
04/24/02
Advertisement
Table of Contents
