Hatteland JH 15T17 MMD series User Manual page 41

OSD Menu Functions
Display / Setup / User Settings / Communication / RS-232 - May be factory default.
Function only available in "Full" menu mode.
Configure the built-in HATTELAND® SCOM (Serial Remote Control Interface) to RS-232 protocol which en-
able software/remote control of a single HATTELAND® unit.
The SCOM will enable operators to modify a wide range of parameters available inside the display
controller. Most of the functions described in this section is available, but also additional parameters can be
inspected or adjusted with dedicated software connected to the unit's serial ports (COM). Daisy-chain
operation is also possible by using a second COM port.
More in-depth information and usage about the SCOM, please visit: www.hatteland-display.com
"Product Support/Accessories/HATTELAND® SCOM Series 1)" when made available.
● When selected, a box icon ( ▀ ) will indicate that the selected function has been activated.
Display / Setup / User Settings / Communication / 2-wire RS-485 - May be factory default.
Function only available in "Full" menu mode.
Configure the built-in HATTELAND® SCOM (Serial Remote Control Interface) to RS-485 protocol which en-
able software/remote control of one or several other HATTELAND® units simultaneously.
● When selected, a box icon ( ▀ ) will indicate that the selected function has been activated.
Display / Setup / User Settings / Communication / 4-wire RS-485/RS-422 - May be factory default.
Function only available in "Full" menu mode.
Configure the built-in HATTELAND® SCOM (Serial Remote Control Interface) to RS-485/RS-422 protocol
which enable software/remote control of one or several other HATTELAND® units simultaneously.
● When selected, a box icon ( ▀ ) will indicate that the selected function has been activated.
Display / Setup / User Settings / Communication / Address
Function only available in "Full" menu mode.
Configure the address which the current unit shall be identified as in a SCOM system. Whenever you
communicate with the unit or units, the system will accept parameters or adjustments for that ID alone.
● Level adjust from 0-15 and reflects a unique ID number. Default is 0.
Display / Setup / User Settings / Gamma / x.x
Function only available in "Full" menu mode.
Adjust the overall gamma intensity. You can choose 1.0 (default), 1.6 or 2.0. Higher values will give a much
more brighter/washed out picture even in the darkest areas, i.e. black becomes faint grey. This affects the
whole panel, and all applies to all signal inputs and window overlays (PIP/PBP) inlcuding the OSD Menu
overlay. This will be independent of the actual brightness/contrast adjustment done by the front user
controls like potmeters or buttons.
● When selected, a box icon ( ▀ ) will indicate that the selected function has been activated.
User Controls
IND100064-21
41
INB100036-1 (Rev 15)