Steel City 45960C User Manual page 20

RIVING KNIFE/SPLITTER COMPONENTS
ASSEMBLY
Note: Remove the table insert ( Table insert are gripped
by four magnets on the table).
Fig.14
INSTALLING AND REMOVING
THE RIVING KNIFE/SPLITTER
1. Loosen the knob (C),Line up the riving knife/splitter in
the proper direction to the mounting bracket (B).
SEE FIG.15.
2. Push the Riving Knife/
mounting bracket, make sure the location pin is
properly locked in the hole of the Riving Knife/
(The location hole is on the button side of the Riving
Knife/ splitter ).
3. Tighten the fasting knob(C).
•Remove
1. Loosen the fasten knob (C).
2. Remove the Riving Knife/
bracket.
NOTE: Make sure blade or arbor is at the highest
position before adding or removing the riving
Knife/ splitter .
splitter all the way down into the
SEE FIG.16
splitter out of mounting
Fig.15
Fig.16
BLADE ASSEMBLY
splitter .
Fig. 17
20
C
C
B