Steel City 45960C User Manual page 19

GRANITE EXTENSION WING ASSEMBLY
FOR 35971/35972
CAUTION: The granite extension wing is heavy; two
people are required for assemble.
1.One person put left extension wing on the top of 1.One person put left extension wing on the top of
cabinet. Alignment pin into bottom of wing (A). cabinet. Alignment pin into bottom of wing (A).
SEE FIG.9 SEE FIG.9
Fig.9
2. Another person locks 4 bolts (A) with flat and spring 2. Another person locks 4 bolts (A) with flat and spring
washer and from the bottom of cabinet and tighten it. washer and from the bottom of cabinet and tighten it.
SEE FIG. 10 SEE FIG. 10
Fig.10
Need not adjust the flatness for Need not adjust the flatness for
NOTE:
extension wings after assembling. extension wings after assembling.
Because we have done the pre- Because we have done the pre-
adjustment and pre-setting of the adjustment and pre-setting of the
extension wings for the flatness in factory. extension wings for the flatness in factory.
A
B
3.The user can fine tune the flatness for the extension 3.The user can fine tune the flatness for the extension
Wings. Wings.
4.To loose 4 screws (B) by 6.0mm Allen Wrench;
5.To loose 4 setting screws (C) by 2.5mm Allen wrench.
SEE FIG.11
Fig.11
C
6. Using an open wrench ( ) to adjust the 4 elevation
screws ( ) to raise or lower the extension wing to the E
table. SEE FIG.12
Fig.12
7.Use a straight edge across to the main table and
extension wings, checking the flatness of both main and
extension wings. SEE FIG.13
Fig.13
8.Make sure both wings are aligned, if not, refer to step (6)
until completely adjusted.
9. Using a 6.0mm Allen wrench to secure 4 screws (B).
The assembly method for 35963/35964
Extension wing is the same as 35971/35972
19
D
D
E