Barco DP-1500 Installation Manual page 59

Image 6-14
8. Reinstall the UV blocker assembly as illustrated. Make sure that the xenon bulb lamp is properly supported by the lamp supporting
mechanism in the centre of the UV blocker. Use the opening at the side of the lamp house to guide the supporting pin of the
xenon bulb lamp into the anode supporting mechanism.
Image 6-15
9. Secure the UV blocker by fastening the four thumbscrews as illustrated.
Note: Please ensure that the thumb screws turning wires are flash with the cover or interference will occur while inserting the
lamp house into the projector.
Image 6-16
10.Fasten the cathode side of the xenon bulb lamp using a hexagon socket head screw M6 x 40 and a plane washer as illustrated.
Use a torque of 2,5 Nm to fasten the hexagon socket head screw. Use for that a torque wrench with a 5 mm Allen socket.
Caution: Make sure that the both pins (reference A of image 6-17) of the cathode adapter remain engaged in the foreseen
slots. Therefor, use one hand to keep the xenon bulb lamp into position while inserting the hexagon socket head
screw.
R59770091 DP-1500 06/01/2009
6. Lamp & lamp house
55