12. Servicing
4. Slightly turn the red colored control knob number 3 until the red pattern in the upper right of the projected image converges with
the blue pattern.
Image 12-12
5. Repeat step 3 and 4 until coincidence is obtained of the red pattern in the lower left and upper right of the projected image.
6. Repeat from step 2 until full coincidence is obtained of the red pattern in the center, lower left and upper right of the projected
image.
7. Carefully secure the position of the DMD assembly by tightening the four convergence lock screws (reference 7 of image 12-9)
of the red channel. Fasten the screws crosswise with small adjustments to each screw. Use a 2,5 mm Allen wrench.
108
3
6
R59770091 DP-1500 06/01/2009