Adjusting The Parking Brake - Husqvarna Rider 15V2 AWD Operator's Manual

Adjusting the parking brake Rider 15V2
The parking brake is adjusted as follows:
1. Loosen the locking nuts (1).
2. Tension the cable using the adjuster screw (2)
until the play in the cable is taken up.
3. Tighten the locking nuts (1).
4. The parking brake should be checked again
after the adjustment has been made.
WARNING!
A poorly adjusted parking brake
can result in reduced braking
ability.

Adjusting the Parking Brake

Rider 15V2 AWD
Check that the parking brake is adjusted correctly
by placing the machine on a slope with the front
and rear axles disengaged. Apply and lock the
parking brake. When the machine does not stand
still, the parking brake should be adjusted accord-
ing to the following.
1. Remove the left-hand wing cover.
2. Release the lock nuts (1).
3. Tension the wire with the adjusting screw (2)
until all the play in the wire is taken up.
4. Tighten the lock nuts (1).
5. On completion of the adjustment the brake
should be re-checked.
6. Assemble the left-hand wing cover.
WARNING!
A poorly adjusted parking brake
can result in reduced braking
ability.
28
– English
MAINTENANCE