Adjusting The Parking Brake - Husqvarna Rider ProFlex 18 Operator's Manual

Adjusting the parking brake

The parking brake is adjusted in the following manner:
1. Remove the transmission cover. Loosen both
screws (one on each side) and lift off the
transmission cover.
2. Unhook spring (A) from the screw (B) on the right-
hand side
3. Check that the parking brake is not on.
4. Adjust the play between the casing and the
adjustment screw to 1 mm when you pull the
casing.
Adjust with the nuts on the adjustment screw.
5. Tighten the nuts moderately to avoid damaging
the threads.
6. Replace the spring (A).
7. Check that the parking brake works.
WARNING!
A poorly adjusted parking brake can
result in reduced braking ability.
MAINTENANCE
6008-209
A
B
6020-005
35
English-