To Start An Engine With A Weak Battery - Husqvarna Rider 15V2 AWD Operator's Manual

Hide thumbs Also See for Rider 15V2 AWD:
Table of Contents

Advertisement

To start an engine with a weak battery

WARNING!
Lead-acid batteries generate
explosive gases. Keep sparks,
flame and smoking materials
away from batteries. Always wear
eye protection when around
batteries.
If your battery is too weak to start the engine, it
should be recharged.
If "jumper cables" are used for emergency starting,
follow this procedure:
IMPORTANT INFORMATION
Your mower is equipped with a 12-volt
negative grounded system. The other
vehicle must also be a 12-volt negative
grounded system. Do not use your
mower battery to start other vehicles.
To attach jumper cables
Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking
care not to short against chassis.
Connect one end of the BLACK cable to the
NEGATIVE (-) terminal of the fully charged
battery.
Connect the other end of the BLACK cable to a
good CHASSIS GROUND, away from the fuel
tank and battery.
To remove cables, reverse order
BLACK cable first from chassis and then from
the fully charged battery.
RED cable last from both batteries.
DRIVING
Jumper cables connection
19
English –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rider 15v2

Table of Contents