When Printed Sheets Overflow From The Exit Tray - Toshiba e-studio2050c Troubleshooting Manual

When Printed Sheets Overflow from the Exit Tray

When thin, small size paper (A4-R/LT-R or smaller) is used, the end of the sheets may get stuck in the exit
tray walls. If 300 or more sheets are printed under such condition, some printed sheets may be pushed out of
the exit tray.
In the case above, installing the paper exit stopper at the designated location of the exit tray will increase the
amount of recommended plain paper that can be loaded on to the exit tray to about 500 sheets.
When printing a large number of large size sheets such as A3 and A4/LD and LG, place the paper exit
stopper back in its original location.
When the finisher or inner tray is installed in the equipment, use the paper exit stopper installed in its
original location.
Removing the paper exit stopper from its original location
1 Unfold the paper exit stopper located on the left of the
exit tray and remove it from its groove while pushing
the fulcrum inward.
Installing the paper exit stopper in the designated location for improving paper exit
1 Turn the tip of the paper exit stopper to the left and
insert the paper exit stopper fulcrum into the groove
on the exit tray.
Placing the paper exit stopper back in its original location
Remove the paper exit stopper from the groove on the exit tray while pushing its
1
fulcrum inward.
Install the paper exit stopper in the groove on the left
2
of the exit tray.
1 TROUBLESHOOTING FOR THE HARDWARE

When Printed Sheets Overflow from the Exit Tray

65