Table of Contents
Advertisement
QUICK START
The configuration of the scanner can be done by reading the setup barcodes contained in
this manual or via the ScanMaster software.
This section describes the procedure of configuring the scanner by reading the setup
barcodes and provides some examples for demonstration.
Note: If RS-232 or USB Virtual COM is selected for output interface, the host can directly
send serial commands to configure the scanner.
For example, run HyperTerminal.exe and type the 6-digit command located under
each setup barcode. Refer to
Appendix II Host Serial
Update
Commands.
5
- Quick Links:
- Enter Configuration Mode
- Scan Modes
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 1504 and is the answer not in the manual?
Questions and answers