Fan - Toshiba PORTEGE M300 Maintenance Manual

4.18 Fan

4.18 Fan

Removing the fan
To remove the fan, follow the steps below and refer to figure 4-30.
1. Disconnect the fan cable from the connector CN8770 on the system board.
2. Remove the following screws and remove the fan.
M2.0x4.0B
?
M2.0x4.0B BIND
Installing the fan
To install the fan, follow the steps below and refer to figure 4-30.
1. Install the fan and secure it with the following screws .
M2.0x4.0B
?
2. Connect the fan cable to the connector CN8770 on the system board.
CAUTION: Arrange the fan cable away from C9013 and C9014 on the system board.
4-44
BIND screw
Fan
Figure 4-30 Removing the fan
BIND screw
4 Replacement Procedures
? 2
C9013 & C9014
CN8770
? 2
PORTEGE M300 Maintenance Manual (960-504)