Toshiba PORTEGE M300 Maintenance Manual page 283

4.21 Modem
Modem jack
Insulator 2
Installing the modem jack
To install the modem jack, follow the steps below and refer to figures 4-34 and 4-35.
1. Set the modem jack to the system board and cover the core of modem cable with
insulator 2.
2. Passing the modem cable through the slits, arrange the modem cable and connect it to the
connector CN3001 on the system board.
3. Secure the modem cable with the insulator 1.
4. Connect the modem cable to the connector of the MDC.
5. Connect the MDC straight down to the connector CN3000 on the system board.
6. Secure the MDC with the following screws .
M2.0x4.0Z
?
4-50
Insulators 1
Core
Slit
Figure 4-35 Removing the modem jack
BIND screw
4 Replacement Procedures
? 2
PORTEGE M300 Maintenance Manual (960-504)
CN3001