Toshiba PORTEGE M300 Maintenance Manual page 262

4 Replacement Procedures
3. Open the display and remove the following screw securing the GND cable and cover
assembly.
M2.0? 6.0B
?
4. Remove the following screws securing the cover assembly.
M2.0? 6.0B
?
5. Disconnect the LCD harness from the connector CN5600 on the system board.
6. Disconnect the inverter harness form the connector CN8812 on the system board.
7. Disconnect the LAN harness from the connector CN4100 on the system board.
8. Disconnect the speaker cable from the connector CN6180 on the system board.
9. Disconnect the touch pad cable from the connector CN3240 on the system board.
Inverter harness
(Connected to CN8812)
M2.0x6.0B BIND
(securing with
GND cable)
LCD harness
(Connected to CN4100)
PORTEGE M300 Maintenance Manual (960-504)
BIND screw
BIND screw
LAN harness
(Connected to CN4100)
Figure 4-18 Removing the screws and cables
? 1
? 2
M2.0x6.0B BIND
Speaker cable
(Connected to CN6180)
M2.0x6.0B BIND
Touch pad cable
(Connected to CN3240)
4.10 Display assembly
4-29