Toshiba PORTEGE M300 Maintenance Manual page 224

3.32 SETUP
Ext Keyboard "Fn" key equivalent
Use this option to set a key combination on an external keyboard to emulate the Fn
key on the computer's internal keyboard. Setting a Fn key equivalent will enable
you to use "Hotkeys" by pressing the set combination in place of the Fn key. The
following items can be selected for this option:
= Left Ctrl + Left Alt (*1)
= Right Ctrl + Right Alt (*2)
= Left Alt + Left Shift
= Right Alt + Right Shift
= Left Alt + Caps Lock
NOTE: If these selections ((*1) or (*2)) are made, you cannot warm boot the
system by pressing Ctrl + Alt + Del.
(c) Parallel Port Mode
Use this option to set information of Parallel Port Mode.
ECP
Std. Bi-Direct.
NOTE: When using Windows, the setting of "Toshiba HW setup" is enabled and the
setting of "Parallel Port Mode" is disabled.
(d) Hard Disk Mode
Use this option to select the hard disk mode.
Enhanced IDE (normal)
Standard IDE Select this mode when using an OS which does not support the
3-108
KEYBOARD
= Left Ctrl + Left Alt
Sets the port mode to Extended Capabilities Port (ECP). For
most printers, the port should be set to ECP. (Default)
Sets the bi-directional setting. This setting should be used with
some other parallel devices.
Select this mode when the HDD is used for MS-DOS? ,
Windows 95/98/2000/XP, or OS/2? .
Enhanced IDE. When this mode is selected, up to 528MB is
logically available and the rest of the capacity is not usable.
3 Tests and Diagnostics
PORTEGE M300 Maintenance Manual (960-504)
(Default)