Brick Installation - Marquis Solace MQHBZDV3636 Installation Instructions Manual

Brick Installation - For Models MQHBZDV3636/MQHBZDV4236/MQHBZDV4736
INSTALLING BRICK PANELS FOR MODEL MQHBZDV3636/MQHBZDV4236/MQHBZDV4736
1. Remove door glass from the unit by unlatching the 2 latches on top of unit.
2. (MQHBZDV4736 ONLY)
Using a 1/4" nut driver remove two screws from Brick Panel Filler (#1) and discard brick panel filler. (Ref.1)
3. Remove back Log Holder (#2) by removing three screws from face of Log Holder. The Log Holder will have
to be re-installed after the placement of Back Brick Panel. (Ref.1)
4. (MQHBZDV4736 ONLY)
Place optional front bridge ledge (#3) in the area front of false bottom.
5. Place rear Brick Panel (#4) up against the rear of Firebox by tilting top of panel towards you and sliding bot-
tom of Panel over the back of burner system.
6. Loosen screws holding brick clip in position. Rotate clip up out of the way and slide side brick (#5) up
against rear Brick. Side brick must be flush with side wall of Firebox. Rotate clip down over Brick Panel and
tighten screw.
NOTE: Side Brick for MQHBZDV3636 & MQHBZDV4236
Top of side brick has to be tilted forward and hooked over bottom front lip of Firebox first then rotated backward into
position.
7. Re-install Log Holder removed in Step 3.
8. Install log set as per instruction and re-install door.
30