Installing And Charging The Battery Cartridge - Extech Instruments S1500T User Manual

1.2 Installing and Charging the Battery Cartridge

Note: One battery cartridge is included with the printer. Similar to a cordless phone battery,
the printer's battery must be charged before using it.
Extech batteries must be cycled several times to achieve maximum capacity. To
cycle a battery, fully charge it and then allow full discharge through normal use in
the printer
1.2.1 Installing the battery
Note: Refer to the illustration below to install the battery pack in the printer.
Unlock the battery door by sliding the battery door locking tab down.
Open the battery door to an angle of about 90 degrees. Do not force open.
Insert the battery as shown. (Non-contact end first and let the contact end drop into place).
Close and lock battery door by sliding the locking tab up.
Note: Ensure that battery side with 2 contact terminals is facing down to make contact with
the spring probes inside the battery compartment
1500T User's Guide
FIGURE 2: INSTALLING BATTERY CARTRIDGE
Rev 2.1 7