Panasonic KX-TVP50 Installation Manual page 230

B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
Parameter
Intercom
Paging
Sequence
Release for
Intercom
Paging
No Answer
Time for
Intercom
Paging
Announcement
Repeat Cycle
Intercom
Paging Retry
230
Value Range
(Default)
Up to 12 digits con- Specifies the intercom paging sequence required by
the PBX. It can be programmed using up to 12 of the
sisting of 0-9, , #
following 8 letters and 12 dial codes.
and special codes
(FXW)
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Pager Dialling
A: Answer
1-9, 0, , #: Dial Codes
Up to 12 digits con- Specifies the intercom paging release code required by
the PBX. It can be programmed using up to 12 of the 8
sisting of 0-9, , #
letters and 12 dial codes as specified above.
and special codes
(F)
1-30 s When there is no answer, this parameter specifies the
(5) length of time (in seconds) the VPS must wait before
concluding Intercom Paging.
The VPS will return to the caller if the paged party
does not respond before this timer expires.
1-3 times Specifies the number of times the intercom page will
(1) be announced.
Example:
"I have a call for (mailbox owner's name)."
1-10 times Specifies the number of times paging will be retried
(2) when the paging destination is busy or if there is no
answer.
Note: This setting applies when the subscriber has set
only "Intercom Paging" status to enable in Incomplete
Call Handling Status.
Table 62
Description/Function
SYSTEM ADMINISTRATOR'S GUIDE