Panasonic KX-TVP50 Installation Manual page 107

Description
Dial Number
Type of
Device
Use Mode
No. of Retries
Busy Delay
Time
No Answer
Delay Time
Time Frame 1,
2
MON - SUN
CUSTOMISING THE SYSTEM
Value Range
(Default)
Up to 32 Digits of
[1-9,0, ,#,P,T,M,X]
(None)
1. Telephone
2. Beeper
(Telephone)
1. Not Use
2. Continuously
3. Scheduled
(Continuously)
0-3 Times
(0)
0-120 min
(3)
60-120 min
(60)
1-12: h
00-59: min
AM/PM: am/pm
: All Day
Space: No Use
Table 24
Description/Function
Assigns the telephone or beeper number to Device 1,
2 and/or 3.
P: Pause
T: Dial Tone Detection
M: Dial Mode Switching Code (DTMF to Pulse, or
Pulse to DTMF)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
The callback number entry code (X) must be entered
if COS is set to enable and set to beeper.
Use backspace to delete your entry.
Assigns whether device is beeper or telephone.
Not Use: Does not use device.
Continuously: The VPS notifies each time a message
is recorded in the mailbox.
Scheduled: The VPS notifies the subscriber if a
message is left during one of the time frames.
Specifies the number of times a device should be
retried when busy or no-answer.
The time the VPS will wait before retry on busy.
The time the VPS will wait before retry on No
Answer.
Weekly Schedule for Message Waiting Notification.
The schedule is only used when Use Device is set to
Scheduled.
5.5 SETTING MAILBOXES
107