Panasonic KX-TVP50 Installation Manual page 183

Notification Setting - Device 1-3
Parameter
Dial Number
Type of Device 1. Telephone
Use Mode
No. of Retries
Busy Delay
Time
SYSTEM ADMINISTRATOR'S GUIDE
Value Range
(Default)
Up to 32 digits Assigns a telephone or beeper number to Device 1, 2, or
consisting of 1-9, 3. The subscriber can also specify the dial number from
his telephone.
0, , #
P, T, M, X
P: Pause
(None)
T: Dial Tone Detection
M: Dial Mode Switching Code (DTMF to Pulse, or
Pulse to DTMF)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
Note: The callback number entry code "X" must be
included in the number to be called if the Beeper
Callback No. Entry Mode is enabled through COS and
"Type of Device" is set to "Beeper." The proper number
of "Pauses" must be inserted before the callback entry
code.
The Subscriber can also specify the dial number.
Specifies the device to be notified. This is automatically
set to "Beeper" when "X" is used in the Dial Number
2. Beeper
(above). The Subscriber can also specify the type of
(Telephone)
device from his telephone.
1. Not Use Specifies how Device 1, 2, or 3 is to be used. The
2. Continuously Subscriber can also specify the use mode from his
3. Scheduled telephone.
(Continuously)
1.Not Use - Device 1, 2, or 3 is not used for a
notification call.
2.Continuously - Device 1, 2, or 3 is called whenever a
message is recorded in the mailbox.
3.Scheduled - Device 1, 2, or 3 is called on a schedule
basis when a message has been left in the mailbox.
0-3 times Specifies the number of times that a notification call to
(0) Device 1, 2, or 3 should be attempted after a busy or no
answer condition is received
0-120 min Specifies the time (in minutes) the VPS must wait after
(3) a busy condition is received before making a
notification call to Device 1, 2, or 3.
B2 SYSTEM ADMINISTRATION - MAILBOXES
Table 35
Description/Function
183