8.2 WAN Interface
This page is used to configure the parameters for wide area network that connects to
the WAN port of your WLAN Broadband Router. Here you may change the access
method to Static IP, DHCP, PPPoE or PPTP by click the item value of WAN Access
Type.
Static IP
Parameter
Static IP
IP Address
Subnet Mask
Default Gateway
Description
Click to select Static IP support on WAN interface. There
are IP address, subnet mask and default gateway settings
need to be done.
If you select the Static IP support on WAN interface, fill in
the IP address for it.
If you select the Static IP support on WAN interface, fill in
the subnet mask for it.
If you select the Static IP support on WAN interface, fill in
the default gateway for WAN interface out going data
packets.
38