Removing Punch Waste
2
When the punch waste tray of the optional Puncher Unit-L1/M1/N1 becomes full, a screen similar to
the one shown below appears on the touch panel display. Follow the procedure described below to
remove the punch waste.
This procedure is necessary only if the optional Puncher Unit-L1/M1/N1 is attached.
2-46
Finisher-AE1/Saddle Finisher-AE2/Puncher Unit-L1/M1/N1 (Optional)
When closing the front cover of the finisher, be careful not to get your fingers caught, as this
may result in personal injury.
When you have replaced the staple cartridge, be sure to manually reposition the staples in the saddle
stitcher unit. (See e-Manual > Additional Functions.)