Interfaces; Interfaces Between Sub-Modules; Table 1.1 Interfaces Between Sub-Modules - Samsung OfficeServ 7400 General Description Manual

CHAPTER 1. Overview of OfficeServ 7400

1.2 Interfaces

This section describes the interfaces between the sub-modules of OfficeServ 7400 and
between the VoIP elements.

1.2.1 Interfaces between Sub-modules

Categories
LIM/PLIM Inter-
face
GPLIM Interface
GSIM Interface
GWIM Interface
PSTN Interface
ISDN Interface
xDSL/Cable
Modem Interface
Voice Terminal
Interface
1-6

Table 1.1 Interfaces between Sub-Modules

Types
Physical Access IEEE 802.3 10 BASE-TX, IEEE 802.3u 100 BASE-TX
Connector Type RJ-45
Physical Access IEEE 802.3 10 BASE-TX, IEEE 802.3u 100 BASE-TX,
IEEE 802.3z 1000 BASE-SX/LX,
IEEE 802.3ab 1000 BASE-TX
Connector Type RJ-45, SFP (Small Form-factor Pluggable Connector)
Physical Access IEEE 802.3z 1000 BASE-SX/LX,
IEEE 802.3ab 1000 BASE-TX
Connector Type SFP (Small Form-factor Pluggable Connector)
Physical Access IEEE 802.3z 1000 BASE-SX/LX,
IEEE 802.3ab 1000 BASE-TX, V.35(T1/E1), HSSI(T3/E3)
Connector Type SFP, Serial 26-pin connector (non-standard cable),
Serial 50-pin connector
Access Protocol - PPPoE (PPP over Ethernet), PPP (Point to Point Protocol)
- DHCP (Dynamic Host Configuration Protocol)
- HDLC (High-level Data Link Control)
- Frame Relay
Physical Access T1, E1, FXO (Foreign Exchange Office)
Connector Type RJ-45
Access Protocol T1, E1, Loop Start
Physical Access ISDN PRI
Connector Type RJ-45
Access Protocol ISDN PRI
Physical Access IEEE 802.3u 100 BASE-TX Ethernet
Connector Type RJ-45
Access Protocol PPPoE and DHCP
Analogue FXS (Foreign Exchange Station)
Phone
Digital Phone Samsung Digital Phone
Wireless LAN AP 802.11b, WBS24 (Samsung Wireless LAN AP)
(Access Point)
Interfaces
© Samsung Business Communications