Installing Or Removing The Battery - Ozito MFT-012 Instruction Manual

INSTALLING OR REMOVING THE BATTERY

Always switch off the multi function tool before insertion or removal of the
battery (3).
Installing the Battery
• Holding the multi function tool upright and
picking up the battery (3) in your opposite
hand. Place two fingers over the battery
release tabs (4) and insert the battery (3) until
it clicks into place (Fig. 2).
• Do not use excessive force when inserting the
battery (3). If the battery (3) does not slide in
easily, it is not being inserted correctly.
It is also possible that there could be damage to the battery (3), battery
terminals and/or the multi function tool.
Removing the Battery
Depress both the battery release tabs (4) and gently pull the battery (3) out of the
multi function tool.
Battery
The length of service from each charging cycle will depend on the type of work you
are doing. The battery (3) in this multi function tool has been designed to provide
maximum trouble free life.
To obtain the longest possible battery life, we suggest the following:
• Charge batteries for 7-9 hours and use the multi function tool until it runs down
and only slowly operates. Repeat this charge and discharge process 4-5 times.
• Store and charge your battery (3) in a cool area. Temperatures above or below
normal room temperature will shorten battery life.
• Never store batteries in a discharged condition. Recharge them immediately
after they are discharged.
• All batteries gradually lose their charge. The higher the temperature the
quicker they lose their charge. If you store your drill for long periods of time
without using it, recharge the batteries every month or two. This practice will
prolong battery life.
9
Fig. 2